Gratis verzending vanaf € 75
binnen Nederland

Snel in huis
Verzonden vanuit Nederland

Wereldwijde verzending
Naar elke bestemming met UPS

Thuiswinkel Waarborg

Categorieën

4-pin JST PH to JST SH Cable - STEMMA to QT / Qwiic - 200mm long

4-pin JST PH to JST SH Cable - STEMMA to QT / Qwiic - 200mm long
0 beoordeling(en).

Artikelcode: ADA-4424
€ 1,15 Excl. BTW: € 0,95
67 stuk(s) direct uit voorraad leverbaar.

Aantal: In winkelwagen
Hoeveelheid Per stuk
10+€ 1,13 (Excl. BTW: € 0,93)
50+€ 1,09 (Excl. BTW: € 0,90)

Are you a maker in the midst of a STEMMA dilemma? This 200mm long 4-wire cable is a fantastic chimera-cable fitted with Adafruit STEMMA QT / Sparkfun Qwiic JST SH on one end, and STEMMA JST PH connectors on the other. You can sand down the center-nub key on the JST PH side to make it fit in a Grove connector.

Chunkier JST PH connectors come with 2mm pitch, and JST SH (also known as Qwiic) are 1mm pitch. Both have a nice latching feel, while being easy to insert and remove.

This cable can be used with STEMMA or STEMMA QT / Qwiic boards to easily connect sensors and drivers from one board to the other.

Please note you will have to watch for voltages on the power/signal pin when using 3V-only Qwiic sensors with this cable!

  • You can use this to connect any Grove I2C sensor (3-5V) to an I2C host with Stemma QT or Qwiic connectors (3V)
  • You can use this to connect any STEMMA QT (3-5V) sensor to Grove or STEMMA host (5V) board, and vice versa
  • Warning: If you want to connect a Qwiic board (3V power only!) to a Grove or STEMMA host, make sure the power switch is set to 3V

The colors are:

  • Black for GND
  • Red for V+ - For Qwiic boards, 3.3V. For STEMMA QT, 3 to 5V.
  • Blue for SDA
  • Yellow for SCL
Product
Merk: Adafruit
MPN: 4424
Er zijn geen beoordelingen voor dit product.

Beoordeel

Je naam:


Je beoordeling: Note: HTML-code wordt niet vertaald!

Oordeel: Slecht           Goed

Voer onderstaande code in: