Adafruit I2S 3W Stereo Speaker Bonnet for Raspberry Pi
Description
Hey Mr. DJ! Turn up that Raspberry Pi mix to the max with this cute 3W Stereo Amplifier Bonnet for Raspberry Pi. (It's not big enough to be an official HAT, so we called it a bonnet, you see?) It's the exact same size as a Raspberry Pi Zero but works with any and all Raspberry Pi computers with a 2x20 connector - A+, B+, Zero, Pi 2, Pi 3, etc. We've tested it out with Raspberry Pi OS (the official operating system) and Retropie.
This Bonnet uses I2S a digital sound standard, so you get really crisp audio. The digital data goes right into the amplifier so there's no static like you hear from the headphone jack. And it's super easy to get started. Just plug in any 4Ω to 8Ω speakers, up to 3 Watts, run Adafruit's installer script on any Raspberry Pi, reboot and you're ready to jam!
Each order comes as a fully tested and assembled PCB and 2x extra terminal blocks. No soldering required. You can either plug one of our enclosed speaker sets right into the JST jack in the middle or you can connect any speaker you like to the terminal blocks, like our 4Ω 3W or 8Ω 1W.
Don't forget to make sure you have a good strong 5V power supply - especially if you're using the 3W 4 ohm speakers!
Raspberry Pi and speakers not included!
Reviews
Add to Wish List
Adafruit I2S 3W Stereo Speaker Bonnet for Raspberry Pi
This 3 inch speaker is perfect for any audio project that requires 8 ohm impedance and 1W or less power. The speaker has four mounting holes (distance between holes is 60mm)
This stereo speaker set is a great solution for any audio project where you need an impedance of 4 ohms and power of 3W or less. Because they are sealed speakers they give a full sound despite their small size.
This is the smallest Raspberry Pi available at the moment, now with the GPIO-header presoldered. The board is just half the size of a Raspberry Pi Model A+, but with more capabilities!