Rugged and lightweight, this 17 Watt solar panel with the V88 laptop battery provides fast solar charging for laptops (including MacBooks with an optional adapter), digital cameras, GoPros and tablets.Features24,000mAh V88 Laptop Battery
4x Corner Mounts Included
Panel: IPX7 Waterproo..
Power your project with this handy battery holder for two CR2032 button cells. There is an on/off switch at the top, and the wire length is approximately 15 cm.SpecificationsWeight: 5g (11g including batteries)
Dimensions: 53 x 23 x 6 mm
Output: 6V 220mAhBatteries not included!..
This battery holder offers space for 3x AAA batteries in series, perfect for powering different projects. This particular holder has an on/off switch and is suitable for 3.3V projects which require a 2-pin JST-PH 2.0 connector for e.g. Li-Ion/Poly batteries.Note:When using rechargeable Ni..
Make a nice portable power pack with this 4 x AA battery holder. It fits any alkaline or rechargeable AA batteries in series. There's a snap on cover and an on/off switch which can be handy when wiring to something without a switch.The four batteries are held in series, for a nominal output ..
Make a portable power brick with plenty of juice! Use Alkaline AA's for a 9V 3000-4000mAh power supply, or rechargeable NiMH for 2000mAh 7.5V supply. Either one is good for running electronics that have a 5V voltage regulator (thus requiring a 7V+ supply). Will last about 10 times longer than a ..
When you need a portable 12V power pack, this big holder will do the job! The holder will store 8 AA batteries end to end, to give approximately 12VDC output with up to 2 amp peak current draw. This configuration holds the batteries securely, even if being bumped/moved around...
This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just large enough for a #5 or smaller needle to pass through. One tab connects to common ground (negative) and the other ta..
Keep your power source safe and toasty in these waterproof 2xAA battery holders. They're just like classic switched battery holders, but designed for survival! The case has a rubber gasket around the edge of the case (its black and hard to see in the photos but it is there) and attaches together..