Besteld op ma-vr voor 17:00u
is zelfde dag verzonden

Snel in huis
Verzonden vanuit Nederland

Wereldwijde verzending
Naar elke bestemming met UPS

Thuiswinkel Waarborg


Grove - PH Sensor Kit (E-201C-Blue)

Grove - PH Sensor Kit (E-201C-Blue)
0 beoordeling(en).

Artikelcode: SS-110020291
€ 21,50 Incl. 21% BTW
Excl. BTW: € 17,77
11 stuk(s) direct uit voorraad leverbaar.

Aantal: In winkelwagen
Hoeveelheid Per stuk
10+€ 20,86 (Excl. BTW: € 17,24)
50+€ 20,21 (Excl. BTW: € 16,70)

Are you trying to find an easy to use and cost-effect PH sensor/meter? Do you want to use a PH sensor/meter with Arduino or Raspberry Pi? Well, this new Grove - PH Sensor will meet all your needs. The PH sensor measures the hydrogen-ion activity in water-based solutions, we usually use it to measure the PH of a liquid. It is widely used in the chemical industry, the pharmaceutical industry, the dye industry, and scientific research where acidity and alkalinity testing is required. The drive board in this kit support both 3.3V and 5V system. And with the stander BNC probe interface and Grove connector, it is very convenient to work with Arduino and Raspberry Pi.


  • Widely used in chemical industry, pharmaceutical industry, dye industry, and scientific research
  • Support with both Arduino and Rasberry Pi 
  • Compact size for easy deployment and cost-effective
  • Resolution: at most ±0.15PH (STP)
  • Probe replaceable



  • Operating voltage3.3V/5V
  • Range0-14PH
  • Resolution±0.15PH(STP)
  • Response time<1min
  • Probe InterfaceBNC
  • Measure temperature0-60℃
  • Internal resistance≤250MΩ(25℃)
  • Alkali error
  • 0.2PH(1mol/L)Na+,PH14)(25℃)


Before being measured, the electrode must be calibrated with a standard buffer solution of known PH value. In order to obtain more accurate results, the known PH value should be reliable, and closer to the measured one.

When the measurement is completed, the electrode protective sleeve should be put on. A small amount of 3.3mol / L potassium chloride solution should be placed in the protective sleeve to keep the electrode bulb wet.

The leading end of the electrode must be kept clean and dry to absolutely prevent short circuits at both ends of the output, otherwise it will lead to inaccurate or invalid measurement results.

After long-term use of the electrode, if you find that the gradient is slightly inaccurate, you can soak the lower end of the electrode in 4% HF (hydrofluoric acid) for 3-5 seconds, wash it with distilled water, and then soak in potassium chloride solution to make it new.

Merk: Seeed Studio
MPN: 110020291
Er zijn geen beoordelingen voor dit product.


Je naam:

Je beoordeling: Note: HTML-code wordt niet vertaald!

Oordeel: Slecht           Goed

Voer onderstaande code in:

Tags: seeed, grove, ph, sensor