In verband met Koningsdag zijn wij vrijdag 27 april gesloten. Bestellingen worden in Nederland niet op vrijdag bezorgd. Bestellingen geplaatst na 26 april 17.00 uur worden pas weer maandag 30 april verwerkt.
Categorieën

LilyPad FTDI Basic Breakout - 5V

LilyPad FTDI Basic Breakout - 5V
0 - 0 beoordeling(en).
Artikelcode: SF-DEV-10275

€ 17,50 Excl. BTW: € 14,46
14 op voorraad voor directe levering.
Vandaag besteld, zaterdag in huis.

Aantal: In winkelwagen

Hoeveelheid Per stuk
10+€ 16,63 (Excl. BTW: € 13,74)
50+€ 15,75 (Excl. BTW: € 13,02)
  • Gratis verzending vanaf € 50 binnen Nederland en België
  • Verzending via PostNL & UPS
  • Snelle levering uit eigen NL magazijn

This is the LilyPad revision of our FTDI Basic. It is the same as the other FTDI Basic, but has a purple LilyPad board which is half the thickness.

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.

The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is CTS. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.

This board has TX and RX LEDs that make it a bit better to use over the FTDI cable. You can actually see serial traffic on the LEDs to verify if the board is working.

This board was designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!). The Arduino Pro boards and LilyPads use this type of connector.

One of the nice features of this board is a jumper on the back of the board that allows the board to be configured to either 3.3V or 5V (both power output and IO level). This board ship as 5V, but you can cut the default trace and add a solder jumper if you need to switch to 3.3V.

Product
Merk: SparkFun Electronics
Er zijn geen beoordelingen voor dit product.

Beoordeel

Je naam:


Je beoordeling: Note: HTML-code wordt niet vertaald!

Oordeel: Slecht           Goed

Voer onderstaande code in: